Pollen Crusher™ – 15T Hydraulic Rosin Press

The maximum heat level for this machine is 250°C

35-40g material per pressing at a 30% yield = 10.5-12g concentrate / pressing. Twenty (20) presses per hour would yield 210-240g concentrate per hour.

Note: All yields are estimates and depend on a number of variables, including but not limited to the following: quality of material, type and size of pressing bags, pressing temperature, and more.

There are five recommended ways that will contribute to producing a higher quality resin:

• • Choose the best materials: Make sure you choose the best quality plant for your budget. Pressing the material as soon as it’s been dried and cured will play a massive role in achieving a higher quality resin. 
  • Choose the best humidity: It is recommended that for best results the relative humidity content of the plant should be between 55%-62%. In order, to determine the relative humidity it is advised that you invest in a hygrometer.  
  • Choose the best temperature: The amount of heat and pressure applied to your material by the heated plate will determine the speed and consistency that the trichomes liquify. It is down to preference what heat you have it on and as some people prefer a quick hot press rather than slow press at lower temperature.  A cold press at 160°F/71°C – 190°F/87°C for 1 – 5 minutes will produce a thick, batter-like consistency with excellent terpene preservation, however, this is known to produce lower yields. A hot ress at 190°F/87°C – 220°F/104°C for 45 seconds – 3 minutes will  produce an oily or shatter-like consistency product with excellent terpene preservation at 220°F or below which will produce higher yields than the cold press.
  • Choose the right micron bags: Using filter bags to prevent material getting into your final product are highly recommended.
  • Choosing the correct pressure: Similar to temperature and time, applying the right amount of pressure can be tricky. If you apply not enough pressure and it won’t be enough to separate out the oils; apply too much pressure and you get what’s called a “blow out”, where plant material leaches into your concentrate. Ideally, pressure ranging from 550 psi to 1500 psi is good for flower rosin, with maximum quality occurring at the lower end of that range.

In order to get the highest amount of yield possible we highly advise using one of our pollen press products. For this rosin press we would recommend our Rectangular Pre-Press Mould. Pressing your material before you’ve started the rosin pressing process will guarantee a higher amount of resin is produced.

This machine is not lightweight, however, it splits into 3 sections for easier transportation

Yes, the Pollen Crusher rosin press has a hydraulic compressive mechanism

This is a machine for the hardcore rosin producers and it will produce more resin than any of our other machines.

Once turned on, you can toggle the desired temperature by pressing the ‘set’ button, you’ll notice the temperature on the screen starting to flash, at this point you can alter the desired temperature by pressing and/or holding the up or down buttons. 

Once you’ve reached your desired temperature you can press hold the ‘set’ button once more to move onto the timer settings where you’ll be able to set your countdown timer in units of seconds. Once you’re ready to confirm your settings, simply hold the ‘set’ button and this will lock in your settings and take you back to the home screen where you’ll notice the temperature start moving towards the one you just set.

Yes it comes with the following:

• 50x Parchment Papers
• 1x Rosin Tool Kit
• 1x Rosin Containers
• 1x User Manual + Power Cable

Flower Input Capacity: 35-40g (May vary depending on density)

Yes, the Pollen Crusher comes with a 2-year warranty.