Pollen Pincher™ – 1T Manual Rosin Press

2g material per pressing at a 22.5% yield = 0.45g concentrate / pressing. Twenty (20) presses per hour would yield approximately 9g of concentrate per hour.

Note: All yields are estimates and depend on a number of variables, including but not limited to the following: quality of material, type and size of pressing bags, pressing temperature, and more.

There are five recommended ways that will contribute to producing a higher quality resin:

• • Choose the best materials: Make sure you choose the best quality plant for your budget. Pressing the material as soon as it’s been dried and cured will play a massive role in achieving a higher quality resin. 
  • Choose the best humidity: It is recommended that for best results the relative humidity content of the plant should be between 55%-62%. In order, to determine the relative humidity it is advised that you invest in a hygrometer.  
  • Choose the best temperature: The amount of heat and pressure applied to your material by the heated plate will determine the speed and consistency that the trichomes liquify. It is down to preference what heat you have it on and as some people prefer a quick hot press rather than slow press at lower temperature.  A cold press at 160°F/71°C – 190°F/87°C for 1 – 5 minutes will produce a thick, batter-like consistency with excellent terpene preservation, however, this is known to produce lower yields. A hot press at 190°F/87°C – 220°F/104°C for 45 seconds – 3 minutes will  produce an oily or shatter-like consistency product with excellent terpene preservation at 220°F or below which will produce higher yields than the cold press.

• Choose the right micron bags: Using filter bags to prevent material getting into your final product are highly recommended.

• Choosing the correct pressure: Similar to temperature and time, applying the right amount of pressure can be tricky. If you apply not enough pressure and it won’t be enough to separate out the oils; apply too much pressure and you get what’s called a “blow out”, where plant material leaches into your concentrate. Ideally, pressure ranging from 550 psi to 1500 psi is good for flower rosin, with maximum quality occurring at the lower end of that range.

In order to get the most amount of resin we highly recommend purchasing our Pre-Press Mould as this will allow you to double the amount resin you produce which in turn will guarantee the biggest yields possible!

Yes 

The Pollen Pincher rosin press machine has a manual lever to apply pressure to the material.

The Pollen Pincher is a great machine for those who are new to rosin production and who want to produce rosin on a smaller scale but if you are looking to produce larger amounts of resin then i would take a look at our other rosin press machines as these will all produce more resin.

Press the set button to go to the temperature setting mode for the top plate – press the up or down buttons to select your desired temperature. Press the set button again to go to the temperature setting mode for the bottom plate and again press the up or down buttons until you have selected your desired temperature.

Yes it comes with the following:

• 2x Rosin Scrapers
• 2x Rosin Containers
• 50x Parchment Papers

2g (May vary depending on density)

Yes, the Pollen Pincher comes with 2-year warranty.